top of page

How to Etch Stainless Damascus with Gator Piss® MAX

4 days ago
3 min read

Stainless Damascus used to be a pain to etch. The old way meant heating ferric chloride and gassing out your shop to get any real depth. Gator Piss® MAX was built so stainless etches as easily as carbon. You use it straight from the jug at shop temperature, with no mixing and no heating.

Every maker ends up with their own rhythm, but the process comes down to one idea: etch for depth first, then finish with an etch for color.

Zeus stainless Damascus billet, 154CM and AEB-L

Before You Start: Safety

Gator Piss is an acid etchant. Wear gloves and eye protection, and work in a well-ventilated area.

Step 1: Prep the Blade

Get the blade to its final finish before it ever sees acid. Every scratch you leave will show after the etch. Then clean it with Grime Reaper so oils and fingerprints don't leave blotches. From here on, handle the blade by the tang or with gloves.

Step 2: Etch for Depth

Put the blade in Gator Piss MAX and let it soak. How long depends on how deep you want the topography and how fast your acid is working. Pull it, check it, and go back in until you have the depth you're after. Most makers take a couple of cycles to get there.

Temperature changes everything. The warmer the acid, the faster it works. In a warm shop in summer, MAX will etch a lot quicker than it will in a cold shop in winter. Go by what you see on the blade, not by a clock, and check more often when it's warm.

Step 3: Buff Between Cycles

After each depth cycle, buff the blade lightly to knock off the oxides that build up on the surface. Clearing that layer lets the next cycle bite deeper, and it gives you a cleaner look at how much depth you have.

Step 4: Finish with a Color Etch

Your last etch sets the color. Whatever color the blade comes out of that final cycle is the color you keep, so don't buff after it.

You have two ways to do this final etch:

  • Finish in MAX. One last cycle in MAX, and leave the color it gives you.

  • Finish in Gator Piss Original. If you already have all the depth you want, do the final color etch in Original instead. It colors the steel without adding more depth.

Step 5: Neutralize

Neutralize the blade right after the final etch, the same as with all of our etchants. Use either a commercial Windex that contains ammonia or a baking soda bath. Both work well. Then rinse and dry the blade.

Step 6: Protect

Seal the etch with Gator Skin® to protect the color and the pattern from water, oil and handling.

Quick Recap

  1. Gloves, eye protection, ventilation.

  2. Finish the blade, then clean it with Grime Reaper.

  3. Etch in MAX for depth, a couple of cycles, checking as you go.

  4. Buff lightly between depth cycles to clear oxides.

  5. Make the last etch your color etch, in MAX or in Original. Don't buff after it.

  6. Neutralize in ammonia Windex or a baking soda bath, then rinse and dry.

  7. Seal with Gator Skin.

Warm shop, faster etch. Cold shop, slower etch. Watch the blade, not the clock.

Get the Etchants

Gator Piss MAX, Gator Piss Original, Grime Reaper and Gator Skin are all on our Gator Piss page.

Comments


bottom of page