How to Heat Treat CopperMai: A Knifemaker's Guide
CopperMai heat treats more like a plain carbon steel than most people expect. The copper is on the outside for looks, and the hardening happens in the core. Get that idea right and the rest is following the spec sheet for your bar.
This guide covers the how and why. The exact numbers for your steel are on its heat treat spec sheet, which you'll find on our Heat Treat page.
Heat Treat for the Core, Not the Cladding

CopperMai is copper San Mai: Coppermascus® cladding over a solid high-carbon steel core. The core becomes your edge, so that's the steel you heat treat for. The copper and steel in the cladding go along for the ride.
That's why every CopperMai spec sheet is written for its core steel. Cores can change from one run to the next, so always pull the sheet that matches the bar you bought, not one you used last time.
Before You Start
Heat treat at full thickness, before grinding bevels. Profile the blade first, but leave the bevels for after. A thick blade moves less in the quench, and you'll grind through any scale and surface changes afterward.
Profile it the right way. Copper layers don't play well with laser cutting. Use a water jet, saw or grinder.
Don't forge it. We recommend against forging CopperMai. Profile it from the bar by stock removal instead.
Clean it up. Get oils and shop grime off so heat and quench hit evenly. Grime Reaper works well here.
Keep the Copper Safe
Copper melts at a much lower temperature than steel. Your hardening temperatures are well under that point, but a forge or kiln running hot, or a part left in too long, can push the copper layers past where they should be.
Stay at the temperatures on your spec sheet. Don't "add a little" for insurance.
Watch for hot spots, especially in a forge. An even heat matters more with copper in the stack.
The Quench
Use the quench medium your spec sheet calls for. Never use canola oil. Go into the quench point down, straight down, so both sides cool at the same rate.
The cladding behaves differently from the core in the quench, so a little movement is normal on thin profiles. That's one more reason to heat treat at full thickness.
Temper Right Away
Temper as soon as the blade is cool enough to handle. Follow the tempering cycles on your spec sheet. Most call for more than one cycle, with the blade cooled to room temperature in between.
When you check hardness, test the core at the edge, not the flats. The cladding won't read like the core, and that's by design.
After Heat Treat
Grind your bevels. Keep the blade cool while you grind so you don't undo your temper at the edge. Grinding evenly on both sides keeps the core line centered.
Etch. Clean with Grime Reaper, then etch in Gator Piss® Heavy. If your CopperMai has a 1084/15N20 Damascus core, use Gator Piss Original instead.
Protect it. Seal the etch with Gator Skin®, and treat the flats like carbon steel: dry and oiled or coated.
Get Your Spec Sheet
Every CopperMai we sell has a heat treat spec sheet with the full recipe for its core, from normalizing through quench and temper. Find yours on our Heat Treat page.
Related: CopperMai vs. Coppermascus · San Mai Steel Guide





Comments